(2020-01-20, 10:48 PM)holgerw Wrote: [ -> ] (2020-01-20, 12:24 PM)SkipperEarly Wrote: [ -> ] (2020-01-17, 06:16 PM)holgerw Wrote: [ -> ]Well, just looked with path a bit: environment.inside.bilge.temperature HAS selectable units in the Instrument Output. So no need these hack anymore.
Regards
@holgerw: could you please share a screenshot where you show this unit selection.
I cant even find the environment.inside.bilge.temperature key you mention.
I use signalK 1.20.0 and latest updates of OP2
You only have to use any Path: environment.inside.xxxxxxx.temperature to get the Units selectable in Sk-Instruments.
not available in my installation :
see yourself.[
attachment=719]
what about this: try to put your "xxxxx" into the form and klicking "replace"
PS: this works only in the xxxxxx.yyyyy.*.zzzzz templates !
(2020-01-21, 10:41 AM)holgerw Wrote: [ -> ]what about this: try to put your "xxxxx" into the form and klicking "replace"
PS: this works only in the xxxxxx.yyyyy.*.zzzzz templates !
Sorry, but this is not a helpful comment without a screenshot.
(2020-01-21, 05:52 PM)SkipperEarly Wrote: [ -> ] (2020-01-21, 10:41 AM)holgerw Wrote: [ -> ]what about this: try to put your "xxxxx" into the form and klicking "replace"
PS: this works only in the xxxxxx.yyyyy.*.zzzzz templates !
Sorry, but this is not a helpful comment without a screenshot.
You are nearly done, just chang your template to one with an .*. Inside. Or look into the new manual from openplotter 2.