2021-08-12, 12:58 AM
I've downloaded the 2020_10_27 image to my mac; I ran the RPI imager utility to write it to an SD card (but NOT the SD card that came with the tinypilot -- I'm holding that one safely until I get something new installed).
I'm going to place this new SD card into the TinyPilot computer...but presumably I have to do something to move the new "image" file somewhere and make it the "thing to run when the TP is powered up".
Does anyone have any suggestions for how to get from "I've got an SDCard with an image on it" to "my TP now runs that image when I start it up, rather than version 0.12" ?
--John
Never mind...
I just did the most obvious thing (plugged in the newly-written SD card, applied power) and it showed up saying version 0.24 ... so I guess I'm good to go.
--John
I'm going to place this new SD card into the TinyPilot computer...but presumably I have to do something to move the new "image" file somewhere and make it the "thing to run when the TP is powered up".
Does anyone have any suggestions for how to get from "I've got an SDCard with an image on it" to "my TP now runs that image when I start it up, rather than version 0.12" ?
--John
Never mind...
I just did the most obvious thing (plugged in the newly-written SD card, applied power) and it showed up saying version 0.24 ... so I guess I'm good to go.
--John