OpenMarine

I recently purchased a Pypilot Hat version 0.27, and the small motor controller.

The available schematic for the hat is apparently for a previous version.  It shows a connector J1 for a keypad, but there doesn't appear to be a similar connector on the 0.27 Hat.  Is there a convenient way to connect a keypad to this version of the Hat?  There does appear to be a row of holes for external connections on one edge of the board, but any lables for those holes are hidden by the display.

Try this:
https://pypilot.org/schematics/pypilot_hat.pdf

Thank you.

It would be helpful if you could put the PCB version number on the schematic.

This is a good idea. I will for the next one.