Gps difficulties - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Gps difficulties (/showthread.php?tid=2721) |
Gps difficulties - Cheezeitz51 - 2020-07-07 after some reboots on a fresh install my gps will stop working. It's a rp4 with openplotter 2 with vk 162/ublox 7 gps. Signalk says device or resource busy. I dont see anything else using it though. I have never had this problem before until a couple days ago. It seems when I do the following commands it will start working again (sometimes right after, sometimes it needs rebooted and it will continue to work after some reboots) Sudo killall gpsd Sudo killall -9 gpsd Sudo rm /run/gpsd.sock Gpsd /dev/ttyACM0 Sincr a couple days ago I've done multiple clean installs and tried a different pi. Any ideas why this is happening/how to fix it? RE: Gps difficulties - Cheezeitz51 - 2020-07-07 (2020-07-07, 03:09 AM)Cheezeitz51 Wrote: after some reboots on a fresh install my gps will stop working. It's a rp4 with openplotter 2 with vk 162/ublox 7 gps. Signalk says device or resource busy. I dont see anything else using it though. I have never had this problem before until a couple days ago. It seems when I do the following commands it will start working again (sometimes right after, sometimes it needs rebooted and it will continue to work after some reboots) sorry for the double post Gps difficulties - tkurki - 2020-07-07 So it starts working after gpsd restart, but Signal K reports resource busy. Sounds like you have the device configured both as a serial device and as a gpsd connection? Sent from my iPhone using Tapatalk RE: Gps difficulties - Cheezeitz51 - 2020-07-07 (2020-07-07, 08:23 PM)tkurki Wrote: So it starts working after gpsd restart, but Signal K reports resource busy. Sounds like you have the device configured both as a serial device and as a gpsd connection? It is only configured as a serial device as far as I can tell RE: Gps difficulties - tkurki - 2020-07-08 If the serial device is configured in Signal K why are you using gpsd? Next time SK reports resource busy you can see what process has the port open with sudo lsof | grep ttyACM0 RE: Gps difficulties - Cheezeitz51 - 2020-07-08 (2020-07-08, 09:02 PM)tkurki Wrote: If the serial device is configured in Signal K why are you using gpsd? I don't know, I guess I'm not using it and got confused. It was being used by node, which I killed and then it was being used by pypilot. Which I kill but then it comes back |