2019-10-30, 07:34 PM
I'm currently testing OP2 installed on Buster on a Pi 4 4gb.
Got most things running well including the CAN-USB stick.
I'm having an issue with the GPS feed from my bu-353 gps puck into OpenCPN via Signalk and the Signalk to MNEA0183
In OP2 currently serial connections must go through SignalK so I set up a new serial connection at /dev/tty0 for my GPS puck. This seems to work as the Signalk log shows GPS sentences.
I have enabled GGA/GLL amongst other things in the Signalk to NMEA0183 plugin. I have setup OpenCPN to receive data over TCP from Localhost on port 10110.
The diagnostic shows data coming in, yet for some reason OpenCPN is not showing that the GPS location is active nor showing it on the map.
Is there something I've done wrong?
Got most things running well including the CAN-USB stick.
I'm having an issue with the GPS feed from my bu-353 gps puck into OpenCPN via Signalk and the Signalk to MNEA0183
In OP2 currently serial connections must go through SignalK so I set up a new serial connection at /dev/tty0 for my GPS puck. This seems to work as the Signalk log shows GPS sentences.
I have enabled GGA/GLL amongst other things in the Signalk to NMEA0183 plugin. I have setup OpenCPN to receive data over TCP from Localhost on port 10110.
The diagnostic shows data coming in, yet for some reason OpenCPN is not showing that the GPS location is active nor showing it on the map.
Is there something I've done wrong?