2024-04-12, 03:36 PM
Hi
I have been playing around with Orange Pi for , had Openplotter on a OrangePi PC 2 Plus 2G ram 8G Emmc, but never got installed in the boat.
Now I got a question on Facebook where I answered that this BTT Pi 3d printer Klipper board could be a good board... so I should test it myself...before causing problems!!
The board: https://biqu.equipment/collections/contr...d_source=1
And it does not include Can bus, but has port for an Can accessory: https://biqu.equipment/collections/contr...2289867874
So I got the image for the BTT CB1 that is working with BTT Pi board: https://github.com/bigtreetech/CB1
I think it is an Armbian I tried Armbian Bookworm but was not lucky...
I'll will follow the OPI 5 install maybe, and adapt things
This board is close to OrangePi Zero 2w.. I have a few.. try them later maybe!
I'll report more later /bektorkhan
I have been playing around with Orange Pi for , had Openplotter on a OrangePi PC 2 Plus 2G ram 8G Emmc, but never got installed in the boat.
Now I got a question on Facebook where I answered that this BTT Pi 3d printer Klipper board could be a good board... so I should test it myself...before causing problems!!
The board: https://biqu.equipment/collections/contr...d_source=1
And it does not include Can bus, but has port for an Can accessory: https://biqu.equipment/collections/contr...2289867874
So I got the image for the BTT CB1 that is working with BTT Pi board: https://github.com/bigtreetech/CB1
I think it is an Armbian I tried Armbian Bookworm but was not lucky...
I'll will follow the OPI 5 install maybe, and adapt things
This board is close to OrangePi Zero 2w.. I have a few.. try them later maybe!
I'll report more later /bektorkhan