2017-04-11, 04:42 PM
Hey guys
I'm playing a lot with openPlotter these days. I have a BNo055 chip for IMU, an Adafruit Ultimate GPS and the BMP280 for barometric pressure. I'm getting the pressure allright via a dedicated node on node-red but I though I could just tap into the signalK stream and get everything at the same place, instead of rebuilding nodes on the side. I'm connecting to signalK via websocket, but I seem to only be getting course overground data. I was wondering where I can find the whole list of signalK attributes supported by OP 0.8??
Anybody made progress on this? I would like to have a dashboard with the heel of the boat for instance.
sam
I'm playing a lot with openPlotter these days. I have a BNo055 chip for IMU, an Adafruit Ultimate GPS and the BMP280 for barometric pressure. I'm getting the pressure allright via a dedicated node on node-red but I though I could just tap into the signalK stream and get everything at the same place, instead of rebuilding nodes on the side. I'm connecting to signalK via websocket, but I seem to only be getting course overground data. I was wondering where I can find the whole list of signalK attributes supported by OP 0.8??
Anybody made progress on this? I would like to have a dashboard with the heel of the boat for instance.
sam