(2021-07-15, 08:25 PM)Kever Wrote:(2021-07-09, 03:44 PM)Techstyle Wrote:(2021-07-08, 08:04 PM)Kever Wrote: I have taken the device I purchase, JBtek USB to RS485 Converter Adapter ch340T chip, and tested it on my laptop. It locks the cat /dev/ttyUSB0 output till unplugged. This is probably the problem.
I have ordered the following for it's replacement:https://www.amazon.ca/DTECH-RS485-RS422-Serial-Adapter/dp/B06WGQDV7Z
I have the Dtech one working on my system with a Garmin chartplotter and Raymarine Autopilot. I did have to connect - to + and vice versa though, but I think that will depend on the VHF
Was that specific to send nmea GPS to the VHF radio?
(2021-07-15, 08:42 PM)Kever Wrote:I did the first wiring diagram you posted with negative results. I will try the second one and hop it does the trick.(2021-07-15, 08:25 PM)Kever Wrote:(2021-07-09, 03:44 PM)Techstyle Wrote:(2021-07-08, 08:04 PM)Kever Wrote: I have taken the device I purchase, JBtek USB to RS485 Converter Adapter ch340T chip, and tested it on my laptop. It locks the cat /dev/ttyUSB0 output till unplugged. This is probably the problem.
I have ordered the following for it's replacement:https://www.amazon.ca/DTECH-RS485-RS422-Serial-Adapter/dp/B06WGQDV7Z
I have the Dtech one working on my system with a Garmin chartplotter and Raymarine Autopilot. I did have to connect - to + and vice versa though, but I think that will depend on the VHF
Was that specific to send nmea GPS to the VHF radio?