2021-08-19, 10:31 AM
Hello everyone,
I recently purchased 3 of the new "Arduino Nano Every" boards to use as my motor controller, but I cannot upload the sketch using the standard Arduino IDE.
It returns these two errors....
1. "error -- AVR processor does not provide bootloader support"
2. "error -- cannot find SPM enable bit definition"
Does anyone know.....
1. If this is because the new Nano Every boards are not supported?
2. If I tried to upload the sketches from Rasperry PI without the Arduino IDE, would I still encounter this same problem?(unfortunately I dont have my rasspberry with me to test it right now)
Thanks in advance to anyone who can help!
I recently purchased 3 of the new "Arduino Nano Every" boards to use as my motor controller, but I cannot upload the sketch using the standard Arduino IDE.
It returns these two errors....
1. "error -- AVR processor does not provide bootloader support"
2. "error -- cannot find SPM enable bit definition"
Does anyone know.....
1. If this is because the new Nano Every boards are not supported?
2. If I tried to upload the sketches from Rasperry PI without the Arduino IDE, would I still encounter this same problem?(unfortunately I dont have my rasspberry with me to test it right now)
Thanks in advance to anyone who can help!