2017-11-29, 01:59 AM
(This post was last modified: 2017-11-29, 02:28 AM by DyslexicDancer.)
I'm trying to get openplotter set-up with a dAISy Hat Dual Channel AIS receiver, I have it connected to a Raspberry Pi 3
I've run the Ilker Temir script in the email they sent me, and I think it worked because now I do not have bluetooth anymore, so i think the serial port is available now
But for the life of me I do not understand how I'm suppose to get the dAISy hat to communicate with Openplotter
I think the dAISy Hat is working fine because every 5 or so seconds I get the green LED light flash, but when i look in openplotter I do not see that it has a connection
I've tried setting up a new connection under the NMEA 0183 tab, (Type:Serial Name:ais, Port:ttyS0 Baud:38400 in/ot:in) but no dice
I'm a total noob when it comes to the Raspberry Pi and Linux
Any help would be greatly appreciated
TIA
Tim
I've run the Ilker Temir script in the email they sent me, and I think it worked because now I do not have bluetooth anymore, so i think the serial port is available now
But for the life of me I do not understand how I'm suppose to get the dAISy hat to communicate with Openplotter
I think the dAISy Hat is working fine because every 5 or so seconds I get the green LED light flash, but when i look in openplotter I do not see that it has a connection
I've tried setting up a new connection under the NMEA 0183 tab, (Type:Serial Name:ais, Port:ttyS0 Baud:38400 in/ot:in) but no dice
I'm a total noob when it comes to the Raspberry Pi and Linux
Any help would be greatly appreciated
TIA
Tim