2022-08-08, 08:56 PM
Hi,
I have an issue with my Maiana Antenna: I installed exactly according to the manual.
Working with Op V2, AIS works very fine. I can see boats on the Rhine even though houses and two kilometers are in between, but it doesn't recieve GPS-data. The GPS-LED at the AIS-USB-Adapter flashes very short (and tired) when starting, but that's it.
And then: TX-light is allways on, even if I silence the Adapter, as well with hardware as softwarebutton.
RX-light is flickering every now and then.
I use a cat6 cable, but I think theres no difference to cat5, the usb-cable is ok.
Maiana app Ver 2.1.2
OP Ver. 2
Hardware revision: 11.3.0
Firmware revision: 4.1.0
Type of MCU: STM32L422
Then I tried to setup OP V 3, but here I gave up, after a very fresh and clean install (and reinstall of the signal-k-server), because the Maiana app could never connect to the device.
Any ideas, I dont want to use an extra gps-dongle, if possible.
Thanks in advance
Chr.
I have an issue with my Maiana Antenna: I installed exactly according to the manual.
Working with Op V2, AIS works very fine. I can see boats on the Rhine even though houses and two kilometers are in between, but it doesn't recieve GPS-data. The GPS-LED at the AIS-USB-Adapter flashes very short (and tired) when starting, but that's it.
And then: TX-light is allways on, even if I silence the Adapter, as well with hardware as softwarebutton.
RX-light is flickering every now and then.
I use a cat6 cable, but I think theres no difference to cat5, the usb-cable is ok.
Maiana app Ver 2.1.2
OP Ver. 2
Hardware revision: 11.3.0
Firmware revision: 4.1.0
Type of MCU: STM32L422
Then I tried to setup OP V 3, but here I gave up, after a very fresh and clean install (and reinstall of the signal-k-server), because the Maiana app could never connect to the device.
Any ideas, I dont want to use an extra gps-dongle, if possible.
Thanks in advance
Chr.