(2024-01-30, 09:04 PM)Boatingbaileys Wrote: Hi, Have you setup a hotspot on the Pi and is the Pi connected to any other network? There are changes to the networking in this version as listed a few posts back. Also try turning on mdns in Settings on SignalK.
If you connect to the Pi with another device do you get an address in the network range you have specified above? What security do you have set on that network? WP3 for example?
Lots of good questions. Thanks.
Yes, I did set up a hotspot early on (almost forgot I did as I named it OpenPlotter). I just vnc'd into another pi I have on my boat and was able to change the WiFi to my "OpenPlotter" and did get an expected IP (10.42.0.240). Security is WPA/WPA2. I just turned on mdns, but still no joy. As I mentioned before, it shows up on the dashboard under connection activities even though it did not show up for an Access Request, but no data in the data browser.
I should add that it was working with the previous OP3 rasppi4 server. The only difference with the code openplotter ->OpenPlotter in set_wifi() and 10.10.10.1 -> 10.42.0.1 in set_sk_server().
I have been look at the Signal K Server Logs and noticed several of the following:
Jan 30 21:37:22 sudo: mpstat: command not found
Jan 30 21:37:52 sudo: mpstat: command not found
I searched and found that mpstat is provided by the "sysstat" package so I installed it and I don't see these log messages anymore. But also no change with my SenseESP issues.