2024-05-05, 11:25 PM
(This post was last modified: 2024-05-05, 11:50 PM by Lazzz.
Edit Reason: Added info
)
(2024-05-05, 11:37 AM)Sailoog Wrote: Still not working after reboot?
All seems to work as expected in your system so I do not know why you are not seeing the pop-ups. Try this in a terminal:
openplotter-notifications-visual xxxxx normal testing timestamp
and try this too:
set-notification -v xxxxx normal testing
Let me know if you get any error.
Question, where "alertCategory", "alertSystem" and "alertID" data comes from? I do not have that. what is your Signal k version?
No, still nothing after reboot.
Signal k version is 2.7.2
After running this: openplotter-notifications-visual xxxxx normal testing timestamp
I got this Notification window very briefly, for about 1 or 2 seconds only then disappeared.
After running: set-notification -v xxxxx normal testing
Nothing happened!!
I still didn't get any pop-ups, or anything in the Data Browser, after a reboot when setting the float switch to active / 1, just the correct message from the GPIO App.
I closed all windows to see if there was a very brief pop-up when setting off the float switch but nothing!!
The only place where "alertCategory", "alertSystem" and "alertID" data could be coming from is the GPIO > Digital App because the messages correspond.
I deleted the notifications in the Notifications > Send App, to check if these "alerts" were coming from there but they still showed.
When I added a notification for GPIO20 again I press the Play button & the notification appears in the Data Browser, still showing the "alertCategory", "alertSystem" and "alertID"
When I hit the stop button the message goes to "null".
When I activate the Float pin the CPU Usage briefly jumps from 5% to 14% & when I turn it off it does the same jump again.
Pi5 8GB, NVME SSD 512GB, MacArthur hat, OP4,