2024-05-18, 11:44 PM
(2024-05-17, 09:36 PM)I am wondering if someone can post what is the right configuration to make Moitessier-2 HAT to work in RPi5 loaded with OP4.Thanks in advance for your help!FYI: I have managed to have Moitessier-2 HAT working on RPi4 with both OP3 and OP4.However, with RPi5 / OP4, only the I2C information (Pitch, Heel and magnetic-compas) is getting out. The serial (ttyAMA0) is configured and supposedly connected to signalk, but not delivering any NMEA0183 sentences.In the attached pics you can see that in the checking routine, the SDR AIS is not running !!In all cases I have the pins 27 and 28 taken off at the 40-GPIO connector and the UART jumper installed at the HAT. What should I do to have SDR AIS process to runI really appreciate your help. Thanks a lot! Wrote:(2024-05-17, 10:24 AM)Sailoog Wrote: Can you confirm you are getting data in RPi5 + Moitessier HAT without forcing the pins?
yes , both with and with out MacArthur hat .
i have only the debug jumper .
Pt i have data on
AMA0 , Moltiershat
AMA2 , Nasa Windsystem ( only testet because i havent put on the mast )
AMA4 , AIRMA Log , Depth , Tempertur
[quote pid="30229" dateline="1715978160"]
(2024-05-17, 10:24 AM)Sailoog Wrote: Can you confirm you are getting data in RPi5 + Moitessier HAT without forcing the pins?
yes , both with and with out MacArthur hat .
i have only the debug jumper .
Pt i have data on
AMA0 , Moltiershat
AMA2 , Nasa Windsystem ( only testet because i havent put on the mast )
AMA4 , AIRMA Log , Depth , Tempertur
[/quote]