2024-06-02, 11:03 AM
So i made a fresh SD from Open Plotter 4 Headless, the latest beta.
The headless experience re VNC and network setup was brilliant! Impressive.
The only thing that did not work out of the box was "Apperances | Appearance Settings" - it will not start using the menu. This is minor.
I changed password and hostname, set headless resolution and enabled Serial Port and I2C interfaces.
I changed SSID and password and clicked the "Network" button in OP Settings. All good.
I used OP Serial to connect my GPS-mouse to GPSD. Looks like it's working fine.
Then i installed OP I2C using OP Settings and added my BMP280.
After this, the I2C service still cannot be started, this is from OP Check System:
So... how do i move on from here? Debugging tips, logs et. al. i'm not that well versed in linux/Raspberry/OP4?
Hardware wise polling I2C addresses works fine and PyPilot using the IMU works too (uses I2C but not the service as far as i understand).
An update was done at one point during the whole process, i could not detect any changes in behaviour though.
Thank you so much,
/Dany
The headless experience re VNC and network setup was brilliant! Impressive.
The only thing that did not work out of the box was "Apperances | Appearance Settings" - it will not start using the menu. This is minor.
I changed password and hostname, set headless resolution and enabled Serial Port and I2C interfaces.
I changed SSID and password and clicked the "Network" button in OP Settings. All good.
I used OP Serial to connect my GPS-mouse to GPSD. Looks like it's working fine.
Then i installed OP I2C using OP Settings and added my BMP280.
After this, the I2C service still cannot be started, this is from OP Check System:
Code:
Checking display server... | x11
Checking virtual keyboard... | keyboard-EN.xml
Checking OpenPlotter autostart... | enabled
Checking OpenPlotter packages source... | added
Checking I2C sensors... | I2C enabled | Access to Signal K server validated
↳service not running
Checking Notifications... | service running | Access to Signal K server validated
Checking serial connections alias... | All your serial connections have an assigned alias
Checking OpenCPN... | not running | autostart disabled
Checking Signal K server... | running
Checking serial connections conflicts... | no conflicts
Checking network connections conflicts... | no conflicts
Checking GPIO conflicts... | no conflicts
Checking Power off management... | disabled
Checking Shutdown management... | service not running
Checking touchscreen optimization... | disabled
Checking rescue mode... | disabled
Checking debugging mode... | disabled
Checking WiFi password... | done
CHECK SYSTEM FINISHEDSo... how do i move on from here? Debugging tips, logs et. al. i'm not that well versed in linux/Raspberry/OP4?
Hardware wise polling I2C addresses works fine and PyPilot using the IMU works too (uses I2C but not the service as far as i understand).
An update was done at one point during the whole process, i could not detect any changes in behaviour though.
Thank you so much,
/Dany