2016-05-29, 11:18 AM
Mine is the original one, going to get the chip upgrade when I see it working.
Tried every combination now and not seen any message in inspector. Confident I have open plotter setup correctly with the correct port and baud 38400 but not seen anything in inspector nor have I seen the green led on the serial to usb convertor light. I set open plotter to output to the convertor and the red light was flickering fine though obviously the AIS engine could do nothing with the data.
Thanks,
John
Tried every combination now and not seen any message in inspector. Confident I have open plotter setup correctly with the correct port and baud 38400 but not seen anything in inspector nor have I seen the green led on the serial to usb convertor light. I set open plotter to output to the convertor and the red light was flickering fine though obviously the AIS engine could do nothing with the data.
Thanks,
John