This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How do I pipe temp data from 1W to kplex for distribution as NMEA0183
#3
ops, wait. Probably you want to send this by serial and this version does not work the same way than 0.17.0
Now signal k is at the end instead of kplex and all NMEA 0183 data is sent by TCP 10110 but there is no way to send this by serial. Is this your case?
We should add a new assignment type in Serial tab called NMEA 0183 output.
Reply


Messages In This Thread
RE: How do I pipe temp data from 1W to kplex for distribution as NMEA0183 - by Sailoog - 2018-06-15, 05:07 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)