2018-10-24, 09:14 PM
Hi,
I have a Pi3 running OpenpPlotter 1.2.0
I am using an RTL-SDR which worked fine on a previous version of OpenPlotter.
It is recognised and I have calibrated it as described in the Docs. Gain (48 PPM -212)
When I take a look at the signal I have strong vertical lines running down the screen.
The problem is that no AIS data is appearing in OpenCpn (It is enabled)
Do I need to set up an AIS connection in Kplex?
Any suggestions as to how to fault fine this issue?
The boat is in an area where there is lots of AIS transmissions.
Regards,
Jodel
I have a Pi3 running OpenpPlotter 1.2.0
I am using an RTL-SDR which worked fine on a previous version of OpenPlotter.
It is recognised and I have calibrated it as described in the Docs. Gain (48 PPM -212)
When I take a look at the signal I have strong vertical lines running down the screen.
The problem is that no AIS data is appearing in OpenCpn (It is enabled)
Do I need to set up an AIS connection in Kplex?
Any suggestions as to how to fault fine this issue?
The boat is in an area where there is lots of AIS transmissions.
Regards,
Jodel