bluetooth there's your problem ..just kidding
you dont need the 5g setting in openplotter the Ubiquity bullet takes care of it..it needs poe "power over ethernet"and be configured to connect https://www.cleancss.com/router-default/...ullet_M2HP
looking at that Ubiquity bullet all you need to do is plug it to eth0 choose appropriate setting for your pi version.no bridging , ap, ap\client, ap+client if using a dongle
it is basically a router, repeater so it will give the pi an ip address and should share eth0 with your wifi AP on the pi.
the 5g settings in openplotter are for the onboard wifi
you dont need the 5g setting in openplotter the Ubiquity bullet takes care of it..it needs poe "power over ethernet"and be configured to connect https://www.cleancss.com/router-default/...ullet_M2HP
looking at that Ubiquity bullet all you need to do is plug it to eth0 choose appropriate setting for your pi version.no bridging , ap, ap\client, ap+client if using a dongle
it is basically a router, repeater so it will give the pi an ip address and should share eth0 with your wifi AP on the pi.
the 5g settings in openplotter are for the onboard wifi