2020-01-11, 05:19 PM
I have a motor controller i bought from you a couple of years ago.
I would like to update it ?
should I?
What is the best way from the current code on your git?
Also I am trying to connect a 10K potentiometer to act as a rudder sensor.
On the circuit board I see 3 pads 1 square I assume is +5V and 2 that are boxed in the silkscreen. How do i connect this to a potentiometer? please don't say "with wires;/"
Thanks
I would like to update it ?
should I?
What is the best way from the current code on your git?
Also I am trying to connect a 10K potentiometer to act as a rudder sensor.
On the circuit board I see 3 pads 1 square I assume is +5V and 2 that are boxed in the silkscreen. How do i connect this to a potentiometer? please don't say "with wires;/"
Thanks