This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
update motor controller

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
update motor controller
seandepagnier Offline
Moderator
*****
Posts: 2,184
Threads: 20
Joined: Jun 2016
Reputation: 64
#5
2020-01-13, 02:36 AM
You are going to need to get the rudder on A4 to be in range from 0-1.1 volts. There is normally a voltage divider of 30k and 100k resistors to convert from the 0-5v range. Otherwise you should just put a 30-40k resistor in series with your 10k potentiometer.
Find
Reply


Messages In This Thread
update motor controller - by ddelorme - 2020-01-11, 05:19 PM
RE: update motor controller - by seandepagnier - 2020-01-12, 03:58 AM
RE: update motor controller - by ddelorme - 2020-01-12, 01:29 PM
RE: update motor controller - by ddelorme - 2020-01-12, 08:24 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 02:36 AM
RE: update motor controller - by ddelorme - 2020-01-13, 02:15 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 04:54 PM
RE: update motor controller - by ddelorme - 2020-01-14, 11:37 AM
RE: update motor controller - by seandepagnier - 2020-01-14, 11:50 PM
RE: update motor controller - by ddelorme - 2020-01-15, 03:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)