2020-02-09, 06:02 PM
Hehe, I know... you're totally right. It's not just Openplotter, but also a lot of work I've put into other webservers, scripts and configuration I'd rather not do again. But, if there is no way around this ofcourse it's fine to install the OP2 version and just go from there.
I've read that it is possible to upgrade an existing stretch to buster, but not without it's risks. Mainly due to boot partition size and 3rd party software liabilities. So I guess it's rather complicated to upgrade, and you'll end up with a system that cannot be maintained longterm.
Features from OP I need mostly are:
- SDR AIS
- NMEA 0183 and 2000 (canbus)
- WifiAP
- Pypilot
- Tools (ina219)
- i2c sensors (gyro, baro, humid, temperature, magnetic compass, accellero)
- Actions and GPIO (for the shutdown button)
I think that's about it... but Ill take a look at the release notes.
I've read that it is possible to upgrade an existing stretch to buster, but not without it's risks. Mainly due to boot partition size and 3rd party software liabilities. So I guess it's rather complicated to upgrade, and you'll end up with a system that cannot be maintained longterm.
Features from OP I need mostly are:
- SDR AIS
- NMEA 0183 and 2000 (canbus)
- WifiAP
- Pypilot
- Tools (ina219)
- i2c sensors (gyro, baro, humid, temperature, magnetic compass, accellero)
- Actions and GPIO (for the shutdown button)
I think that's about it... but Ill take a look at the release notes.