This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
motor controller voltage

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
motor controller voltage
ddelorme Offline
Member
***
Posts: 205
Threads: 31
Joined: Apr 2017
Reputation: 2
#1
2020-06-02, 08:37 PM
What is the voltage of the rudder sensor? is it 0 to 5v or 0 to 3.3v. I have a  Hall Effect Angle Sensor Encoder
I assumed that it was 5 volt. I there any way to boost the voltage to 5V?
Find
Reply


Messages In This Thread
motor controller voltage - by ddelorme - 2020-06-02, 08:37 PM
RE: motor controller voltage - by seandepagnier - 2020-06-03, 05:29 PM
RE: motor controller voltage - by ddelorme - 2020-06-05, 06:48 PM
RE: motor controller voltage - by seandepagnier - 2020-06-06, 12:46 PM
RE: motor controller voltage - by ddelorme - 2020-06-06, 03:09 PM
RE: motor controller voltage - by seandepagnier - 2020-06-06, 04:45 PM
RE: motor controller voltage - by ddelorme - 2020-06-06, 06:24 PM
RE: motor controller voltage - by seandepagnier - 2020-06-07, 12:08 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)