This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
[CLOSED] No activity and data in signal K for USB/NMEA but logfiles get them

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
[CLOSED] No activity and data in signal K for USB/NMEA but logfiles get them
Phil Offline
Junior Member
**
Posts: 2
Threads: 1
Joined: Aug 2020
Reputation: 0
#3
2020-08-12, 08:34 PM (This post was last modified: 2020-08-12, 08:35 PM by Phil. Edit Reason: Add on )
Hi, great, you were right, removing the checksum check now it works!
Thanks a lot :-)
Perhaps write few words in the doc about this behavior...
Find
Reply


Messages In This Thread
RE: No activity and data in signal K for USB/NMEA but logfiles get them - by Phil - 2020-08-12, 08:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)