2021-04-22, 06:02 PM
(2021-02-16, 12:21 AM)seandepagnier Wrote: I have made my own 3d printed wind . The cost a fraction of davis, and never wear out because it uses hall sensor not a potentiometer, but need a different calibration than davis, otherwise the wires are the same
Any word on when you're ready to sell this new wind sensor? Also, If I have your weather sensor module, how hard is it to switch it over to run the new type of sensor?
I just passed a milestone in my build last night and had pypilot move my inside helm for the first time, so one of the upcoming projects is to get a working wind sensor. As a long shot test, I had tried to wire in my old masthead anemometer, but alas it didn't seem to work putting out vastly inaccurate wind and direction info.