This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
How to existing/old nmea0183 systems?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
How to existing/old nmea0183 systems?
SCarns Offline
Member
***
Posts: 156
Threads: 14
Joined: Oct 2020
Reputation: 4
#2
2021-06-06, 07:21 PM
What's on the other end of those connector cables? Most of those old MFDs came with a connector on one end and bare wire on the other. You should be able to install a terminal strip and connect everything together without cutting anything. Then you have a good place to tie in your RPi serial connector.
Find
Reply


Messages In This Thread
How to existing/old nmea0183 systems? - by seva - 2021-06-06, 11:03 AM
RE: How to existing/old nmea0183 systems? - by SCarns - 2021-06-06, 07:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)