(2022-05-09, 07:10 PM)seandepagnier Wrote: it is an antenna
Got it. Thanks!
OK, after much experimenting, reading the workbook, reading through forum posts, here's where I am. With Sean's help in previous post, I wired my hat to the motor controller. My color scheme highlighted yellow.
In order to get everything working with my PI4 and hat, I had to do the steps at the bottom of this thread.
Now when I start openplotter-pypilot I get a popup that says "hardware serial must be enabled for motor controller communication". I OK that, the app starts, and I go to the "Serial" tab. It says "hardware serial detected" and "Enable" is selectable, but when I select, nothing happens. I start openplotter-pypilot from the command line hoping to see output, error, etc., when I press "Enable" but nothing. See output of console attached. Again, no new output when I press Enable.