2024-03-12, 10:25 AM
I don't think this is useful, but just in case, here's the "Check settings" output:
Code:
Checking touchscreen optimization... | enabled
Checking virtual keyboard... | keyboard-EN.xml
Checking backlight... | disabled
Checking Power off management... | enabled
Checking Shutdown management... | enabled
Checking OpenPlotter autostart... | enabled
Checking rescue mode... | disabled
Checking debugging mode... | disabled
Checking system log file size... | System log file size: 29.14 MB
Checking OpenPlotter packages source... | added
Checking Notifications... | running | Access to Signal K server validated
Checking MAIANA transponder... | running | MAIANA device: /dev/ttyOP_maiana | device settings OK | device settings OK | device settings OK | device settings OK | Access to Signal K server validated
↳check device settings
Checking GPIO... | pigpiod running | openplotter-gpio-read running | Seatalk1 disabled | 1W enabled | pulses disabled | digital disabled | Access to Signal K server validated
Checking I2C sensors... | openplotter-i2c-read running | I2C enabled | Access to Signal K server validated
Checking Network... | NTP server running | correct access point password
Checking CAN devices... | can0
Checking serial connections alias... | All your serial connections have an assigned alias
Checking Dashboards... | Telegraf running | Kip enabled | Node-Red enabled
↳Grafana is not running
Influxdb is not running
Checking OpenCPN... | running | | FP autostart disabled | FP touchscreen enabled
Checking Signal K server... | running
Checking serial connections conflicts... | no conflicts
Checking network connections conflicts... | no conflicts
Checking GPIO conflicts... | no conflicts
CHECK SYSTEM FINISHED