2024-04-01, 06:03 PM
Hi,
Has anyone tried using the Sailor HAT power board alongside MacArthur HAT? I'm keen to retain it as the super capacitor setup is great and it happily powers my 15" touch screen. The Sailor HAT uses GPIO2 and GPIO3 (using I2C addresses 0x6d and 0x51) - looking at the MacArthur HAT documentation these pins are used by MacArthur HAT but can simultaneously be used by other boards, so I'm thinking this will be ok.
It would allow me to combine N2K / NMEA 0183 Waveshare HAT / NMEA 0183 USB dongle all into one HAT which would be great!
Thanks!
Has anyone tried using the Sailor HAT power board alongside MacArthur HAT? I'm keen to retain it as the super capacitor setup is great and it happily powers my 15" touch screen. The Sailor HAT uses GPIO2 and GPIO3 (using I2C addresses 0x6d and 0x51) - looking at the MacArthur HAT documentation these pins are used by MacArthur HAT but can simultaneously be used by other boards, so I'm thinking this will be ok.
It would allow me to combine N2K / NMEA 0183 Waveshare HAT / NMEA 0183 USB dongle all into one HAT which would be great!
Thanks!