2024-03-20, 07:47 PM
Hello everyone,
In my boat I have the ST60+ wind instruments that have a seatalk1 output that I would like to read it using the MacArthur HAT. The official announcement is that Seatalk input does not work with the Raspberry pi 5 because of some gpio change. My questions are:
1. Is the seatalk input something that will never work with the RPI5 due to hardware limitations, or it's something that is just not implemented yet?
2. If it's never going to be fixed, do you have any suggestions on how to read the seatalk input? I see two options, using a raspberry pi 4 instead, or using some external seatalk -> NMEA0183 or usb. Though the latter one is very expensive and I would try to avoid.
3. Other options?
Thanks in advance,
George
In my boat I have the ST60+ wind instruments that have a seatalk1 output that I would like to read it using the MacArthur HAT. The official announcement is that Seatalk input does not work with the Raspberry pi 5 because of some gpio change. My questions are:
1. Is the seatalk input something that will never work with the RPI5 due to hardware limitations, or it's something that is just not implemented yet?
2. If it's never going to be fixed, do you have any suggestions on how to read the seatalk input? I see two options, using a raspberry pi 4 instead, or using some external seatalk -> NMEA0183 or usb. Though the latter one is very expensive and I would try to avoid.
3. Other options?
Thanks in advance,
George
Van de Stadt - Spirit 28