2024-06-30, 03:48 PM
(This post was last modified: 2024-06-30, 04:38 PM by mikekolling.)
Hi
Have installed the Openplotter image on to RPI5.
It works, but annoyingly everytime i run OpenCPN it has forgotten the config from the last time so hence it means-
1. Its in night time mode so cannot read the screen
2. Units are KM/h and depth in Feet even though i set the units the last time.
Is there an easy fix for this?
ALSO! - the toolbar is stuck in the middle and will not move if i try to drag with a mouse.
Some forums reckon the paid for version of Opencpn is better. Would that help?
Mike
Have installed the Openplotter image on to RPI5.
It works, but annoyingly everytime i run OpenCPN it has forgotten the config from the last time so hence it means-
1. Its in night time mode so cannot read the screen
2. Units are KM/h and depth in Feet even though i set the units the last time.
Is there an easy fix for this?
ALSO! - the toolbar is stuck in the middle and will not move if i try to drag with a mouse.
Some forums reckon the paid for version of Opencpn is better. Would that help?
Mike