using pi gpio outputs / pins arduino

[kalle]

HI Sean,

Thanks for coming back back on this. I'm builded a lab for testing. I have the temperature readings as well the voltage and current metering in place. It all works fine and the result is promising. It gives the correct temperature, current and voltage in OpenPlotter Autopilot control. The ruddersense also works, if i ground them the display gives them as fault.

So far, so good.

I'm still left with a smal problem: reverse works, fwd not. If i pull the compass to the right it goes in reverse and gives the right signalling etc. If idle and/or pulled left it says FWD_FAULT. (So that's not caused by the ruddersense)

Any idea? (or is this because i don't have a compass installed yet -> is there a way to trick this?)

Do you use a ruddersensor in your setup? In that case have a look at min and max rudder position settings in client menu. One side positive and the other negative.