Raspberry Pi 4 released!

[rastam4n]

Or if sigK is working could you add an input type 0183, source serial?

This does not seem to work, says it cannot read property 'pipe' of undefined


Only way I have been able to get it to work is to add a serial connection withing opencpn, would love to get this working in OP

For me it worked nicely (my usb gps is an Ublox-8) : 

• in SK : Added one connection, input type NMEA, Enabled Yes, Logging YES, serial port : /dev/ttyACM0, Baud rate : 9600, Validate checksum Yes, Apply, Restart ;
  
• Then added in OpenCPN Options, tab Connection, Add Connection, network, input, TCP, Address : 10.10.10.1:10110, port 2927, priority 1, OK, and worked perfectly ... 
  

(beginner's luck, maybe ...)

well something is amiss... 10.10.10.1:10110 is basically saying "localhost"  port 10110 and then adding port 2927? shouldn't it be 2947?
also everything I have read says to use /dev/ttyUSB0  

Which instructions did you follow .... there is a lot of conflicting posts our there re Opencpn and openplotter and how to do this correctly.

also when you say NMEA do you mean 2000 or 0183?

I have it working but only through opencpn, and only via the serial connection, I read this is not correct and it should be done through SK... not sure why it matters... would be great to understand why