2020-09-12, 06:36 AM
Hi, Just to clarify, I am also struggling with exactly this problem and there didn't seem to be an accepted solution, yet this must be one of the most common setups. I must admit, it was easy in Kplex, but I can't get that to work either now either in V2.0.
I have a laptop running OpenCPN, RPI3+ with Openplotter, ST60 Instrument and Autopilot (NMEA0183), and a Garmin 128 GPS
Is there a simple write up of the settings for such a configuration. I would help if there was an easy way to see the datastream into Signal K like the OpenCPN debug which shows the data and the source.
Thanks
Richard
I have a laptop running OpenCPN, RPI3+ with Openplotter, ST60 Instrument and Autopilot (NMEA0183), and a Garmin 128 GPS
Is there a simple write up of the settings for such a configuration. I would help if there was an easy way to see the datastream into Signal K like the OpenCPN debug which shows the data and the source.
Thanks
Richard