2020-09-27, 01:21 PM
I suffer 100% the same problem, without Moitessier HAT...
The problem appeared when introducing signal K in Opencpn 5.2.0.9 .
I uninstalled and re-installed Signal k twice .
Immediately after re-installation, and rebuilding the connection in Serial, everything seems OK, GPS data are consistent and a FIX will occur after a few seconds. Quitting and rebooting appear to be just nice.
But... later on, say after 10~15 min, Boom, the position jumps everywhere on the planet, impossible to get a fix.
I checked it was not due to the GPS USB connection (port, Hub, GPS module (2 different Ublox8 USB GNSS modules) ...
I am completely disgusted of the insanity of this signal K connection !
I hope we can roll back very quickly to a more stable approach !
So sad it is just not good enough to install aboard ...
The problem appeared when introducing signal K in Opencpn 5.2.0.9 .
I uninstalled and re-installed Signal k twice .
Immediately after re-installation, and rebuilding the connection in Serial, everything seems OK, GPS data are consistent and a FIX will occur after a few seconds. Quitting and rebooting appear to be just nice.
But... later on, say after 10~15 min, Boom, the position jumps everywhere on the planet, impossible to get a fix.
I checked it was not due to the GPS USB connection (port, Hub, GPS module (2 different Ublox8 USB GNSS modules) ...
I am completely disgusted of the insanity of this signal K connection !
I hope we can roll back very quickly to a more stable approach !
So sad it is just not good enough to install aboard ...
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you