2020-10-02, 04:07 PM
openplotter CAN Bus app will do all the job for you but just now I realized that board is oscillator=12000000 and we allow only 8000000 and 16000000. This should be fixed.
until we fix this you should do:
- remove any signal k connection and any device you have set in CAN bus app.
- remove the overlay from /boot/config.txt
- reset
- create a device in CAN Bus app using SPI0, interrupt 25 and oscillator 16000000.
- go to /boot/config.txt and the overlay should have been created again, replace 16000000 by 12000000
- reset
- now you should be able to create a signal k connection from CAN Bus app selecting the device.
until we fix this you should do:
- remove any signal k connection and any device you have set in CAN bus app.
- remove the overlay from /boot/config.txt
- reset
- create a device in CAN Bus app using SPI0, interrupt 25 and oscillator 16000000.
- go to /boot/config.txt and the overlay should have been created again, replace 16000000 by 12000000
- reset
- now you should be able to create a signal k connection from CAN Bus app selecting the device.