Swapped GPIO switches after update

[FabianT]

Hi,

yesterday I've updated to the newr image of tinypilot (from october), been running the 2019 version before.

The pilot works even better, so thats nice.

Two questions:
- the gpio buttons to change course (small and big step) swapped directions. + became minus and so on. Can I swap this back in some config?

- The "wind" pilot is gone. It seems it switches automatically? The display shows + and - AWA. Buttons are now correct (they where wrong on the old version), but I am afraid this is due to the swapped direction in compass mode?

//Fabian

Edit: Tinypilot running on RPI Zero. Switches wired to the GPIO pins.

[seandepagnier]

You can reprogram the buttons from the web interface:

http://192.168.14.1:33333

It takes a few minutes to load.

[FabianT]

Thanks, I will check that.

//Fabian