2021-06-17, 07:59 AM
(This post was last modified: 2021-06-17, 11:22 AM by baltika_no_9.)
Let's assume you are using your iPad to connect and you have installed the VNC viewer app on the iPad
Connect the iPad to the pi's AP just like you would connect it to any other WiFi access point. You say you can see it from the iPad so connect to it using the password you set up in OP
Your iPad network setting should show you are correctly connected and that your pi has assigned the iPad an address in the 10.10.10.0/24 range
Open VNC Viewer on the iPad and I think top right there is a + to add a connection
Type in the address of the pi 10.10.10.1, give it a name and press done then connect
Connect the iPad to the pi's AP just like you would connect it to any other WiFi access point. You say you can see it from the iPad so connect to it using the password you set up in OP
Your iPad network setting should show you are correctly connected and that your pi has assigned the iPad an address in the 10.10.10.0/24 range
Open VNC Viewer on the iPad and I think top right there is a + to add a connection
Type in the address of the pi 10.10.10.1, give it a name and press done then connect