This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cannot read Ethernet input in Signal K
#11
Have you considered answering my last question?

When you say ”ping” what exactly do you mean? Mind that ’ping’ is a specific command to test network connectivity between computers, but it shows no data, just tells if the other computer is reachable.
Reply
#12
Sorry for the delay in coming back to you other things have conspired against me. Thank you for your continued interest.

Would it be simpler to tell me how SK should be configured.

I think you are correct I just used the Terminal command ‘ping’ to reach out to the IP address of the Miniplexer. I assume that the information flowing back was the NMEA data.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)