Thank you for the .bin file. now it works !!!!
connected with my tinypilot!!
The problem now are the buttons. When i press the buttons on the ttgo they are not shown in the "lcd and remote controll setup" webpage to assign them to actions. How do i enable the tinypilot to recognize the buttons ?
Also i see that you use the touch gpio's on the ttgo. Do i have to wire a switch or can i use them as touch inputs?
Could it be these errors on the console?
connected with my tinypilot!!
The problem now are the buttons. When i press the buttons on the ttgo they are not shown in the "lcd and remote controll setup" webpage to assign them to actions. How do i enable the tinypilot to recognize the buttons ?
Also i see that you use the touch gpio's on the ttgo. Do i have to wire a switch or can i use them as touch inputs?
Could it be these errors on the console?
Code:
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:4960
ho 0 tail 12 room 4
load:0x40078000,len:11608
ho 0 tail 12 room 4
load:0x40080400,len:6120
entry 0x400806bc
E (732) spiram: SPI RAM enabled but initialization failed. Bailing out.
wifi timeout, reconnecting wifi 0.0009999275
wifi connecting to kagourakiLab
connect to kagourakiLab MyPass
lcd driver default True False
set language en
loaded 1.866 : 0.0 0.0 1.743 0.06900001 0.05400014
E (4032) gpio: gpio_set_direction(236): GPIO number error
E (4032) gpio: gpio_set_level(178): GPIO output gpio_num error
E (4082) gpio: gpio_set_level(178): GPIO output gpio_num error
wifi connecting to pypilot at 192.168.1.11
connect to host: 192.168.1.11 ... connected!