Thanks for the help and your continued effort @seandepagnier
I tried with the old version on another path, but with no success. I what to mention that I am trying to install from a amd64 linux computer running a debian flavor. I am running a Arduino Nano Every with a ATMEGA4809 chip. I hope this is compatible!?
(2022-10-04, 08:46 PM)Marius Wrote: Thanks for the help and your continued effort @seandepagnier
I tried with the old version on another path, but with no success. I what to mention that I am trying to install from a amd64 linux computer running a debian flavor. I am running a Arduino Nano Every with a ATMEGA4809 chip. I hope this is compatible!?
Attahed is the print from make
you will have to be careful with the atmega4809. It has the capabilities but it may not be worth the effort of dealing with the differences. The code likely has to be modified in several ways. Is there a reason not to use the atmega328?
Thanks @mgrouch for the feedback on how move forward. I will try this tonight.
@seandepagnier
Quote:you will have to be careful with the atmega4809. It has the capabilities but it may not be worth the effort of dealing with the differences. The code likely has to be modified in several ways. Is there a reason not to use the atmega328?
The only reason was that this was available from a source that I could get it quickly. I will try with a older nano clone a friend had lying around.
Hello everybody,
Like Marius, I would prefer to avoid a permanent wifi emission inside my steel boat.
On my installation, OP on a Raspberry 3B and Sean's Tinypilot V 0.32, I got previously an Ethernet communication between both after some manipulations on networking.sh.
Since the installation of OP3 that appears to be a nice improvement of OpenPlotter, I have loosed this possibility.
I would be interested to know the changes done by Marius to obtain the Ethernet link between OpenPlotter and Tinypilot.
Your help would be welcome!
Hello Sean, thank for your interest.
I got ethernet using the usb port and a usb to ethernet converter Gigabit Lan Glaabit. If I remember correctly my actions, I just had rewritten the line number 41 in networking.sh (Pypilot 0.32) to change wlan0 by eth0 (mode "Master + Managed"). I started the Tinypilot in Master + managed mode and once running it was possible to stop both wlan0 on Tinypilot in SSH then wlan9 on the Openplotter raspi. That was probably not a very professional approach, I am a real newby.
It was working fine during the last season, unfortunately I loosed that after installation of OP3.