2023-02-10, 05:58 PM
My setup is PI 4B with Open-Plotter setting 3.4.7 and Pypilot 3.2.9
I have a IMU 9250/6500 connected on the I2C port
I succefully configure the IMU in Pypilot soft.
Now I would like to read pitch and roll in the dashboard.
But this data did'nt appears in signal K.
Should I create a new connection?
Vincent
dashboard.pdf (Size: 61.41 KB / Downloads: 111)
device.pdf (Size: 45.83 KB / Downloads: 85)
I have a IMU 9250/6500 connected on the I2C port
I succefully configure the IMU in Pypilot soft.
Now I would like to read pitch and roll in the dashboard.
But this data did'nt appears in signal K.
Should I create a new connection?
Vincent
dashboard.pdf (Size: 61.41 KB / Downloads: 111)
device.pdf (Size: 45.83 KB / Downloads: 85)