This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SignalK : not getting everything
Hey guys

I'm playing a lot with openPlotter these days.  I have a BNo055 chip for IMU, an Adafruit Ultimate GPS and the BMP280 for barometric pressure.  I'm getting the pressure allright via a dedicated node on node-red but I though I could just tap into the signalK stream and get everything at the same place, instead of rebuilding nodes on the side.  I'm connecting to signalK via websocket, but I seem to only be getting course overground data.  I was wondering where I can find the whole list of signalK attributes supported by OP 0.8??

Anybody made progress on this?  I would like to have a dashboard with the heel of the boat for instance.

Forum Jump:

Users browsing this thread: 1 Guest(s)