Posts: 32
Threads: 4
Joined: Mar 2016
Reputation:
2
The danish Translation for INA260 , is wrong for "Curent" and "Power"
"Ampere" should be Strøm
"Curent" should be Effekt
Sailing in a LM23 23" motor sailor i Danmark . Mostly In Koege bay .
Harbored in SF-Syd , Copenhagen .
Marine Enginer , Pt. working on power plant
Posts: 3,101
Threads: 65
Joined: Mar 2016
Reputation:
301
The translations at the moment are inherited from version 3. We have not yet started translating version 4. Before moving to the stable stage we will announce here that it can now begin to be translated.
Posts: 3,101
Threads: 65
Joined: Mar 2016
Reputation:
301
I have just reinstalled signal k server using openplotter-signalk-installer in OP4 beta and everything works as expected. Not sure how to debug your issue, sometimes there are issues installing packages when your system time is not correct, could be this your case? any problem installing other apps?
Posts: 19
Threads: 0
Joined: Jun 2020
Reputation:
0
2024-03-06, 05:59 PM
(This post was last modified: 2024-03-06, 06:10 PM by Hakan.)
System time is my local UTC +1.
To test I used Settings to install CanBus:
Not either so quick but done after: "added 3 packages in 20m"
Installed Thonny in 10 seconds.
btw: network speed = 192/214 Mbit/s
Posts: 3,101
Threads: 65
Joined: Mar 2016
Reputation:
301
Installed Can bus from openplotter settings: "added 3 packages, and audited 4 packages in 2s"
Corrupted SD? full SD? Internet hiccups in your area? bad connection? just brainstorming...
Posts: 2
Threads: 0
Joined: Mar 2024
Reputation:
0
Hello,
Not sure if it's OP issue,
I've got the AP configuration, and works fine and can share internet. Can connect with my phone and other devices that are 2.4 only.
Although I've selected authe method as WPA/WPA2 Personal The AP is advertised as the WSP WPA network.
SensESP can detect the network, but fails to connect, returning a connection status of 1 (WL_NO_SSID_AVAIL). However, it works fine and can connect to that AP when I remove authentication from the access point and make it open. Therefore, I assume the issue lies with the inability of SensESP to authenticate using WPA. I couldn't find a way to forse WPA2 authentication on OP access point. Is there any config changes that I can do to force the auth protocol.