OpenPlotter 4 roadmap

[aitonos]

HI!

I just bought a Pi5 8GB, installed it the OP4 Beta Starting and I could manage to have GPS from USB Gps. All fine
Now I have tried to use the Moitessier hat2, which I have running every day in my PI4 but  it doesn't work connected to PI5: it doesn't light the lights and in Signal K says there's no incoming activity.

Just as a reminder; I do all the steps in the docs for hacking the moitessier hat:

• In serial settings,  I activate the UART0, get the message that I  will lose BT connection ( BUt I still have it, maybe this is aclue) I restart  PI and then, I get 2 connected devices: TTYAMA0 and TTYAMA10. (but nothing else is connected at the time) (??)
  
• In the serial devices tab, I create an alias  for  TTYAMA0, as  nmea0183 data, 
  
• Then apply, 
  
• then in Connections tab, I make a connection of that device to Signal K with the right bauds 921600,  
  
• Signal K restarts and in the SK dashboard I can see that the connection has been created, wih no activity and  and connection and plugin status  is green and connected
  
• All correct as per instructions, I already did it for OP3 in my PI4!
  

The problem is that in the PI5, there is no activity at all and no lights in the pcb of the hat ( in PI4 the lights are on as soon as the PI starts). I installed it back to the PI4 and it is working as usual, si the HAT is fine.

What am I missing?

Has anybody used the Moitessier HAt in the PI5? Or should I leave it for impossible for now until OP4 is released?

Thanks!!!

You should not get the message about Bluetooth if the Raspberry is detected as model 5.

what power supply are you using in your RPi5?

are you indoor when testing RPi5? try to go to the boat, outdoor or close to a window.

Hi! 

Thanks, but I do get it. I'll make a new fresh install to see. 
I'm using a step-down bucket with 6A capacity and wired to a USB terminal with screws (the bucket has no usb exit just wires positive and negative out).
I'm at the boat, and did it outdoors, the problem is that the lights don't shine as in Pi4. When the Pi4 gets no signal, you always get light during boot and standby.
Anyway, I'll wait until Pypilot is stable and can be calibrated (IMU). 

¡Thanks!