2024-02-20, 02:13 PM
I have moved on to the instructions for setting up my 0183 devices. (Pi5, openplotter 4 beta.)
According to the instructions, I should be editing 3 and 5, but I don't have 5. I have 0,1,2,3,4. 5 is greyed out.
The picture in the docs shows UARTS 0,2,3,4,5. What GPIO pins should I be enabling? (UART3 says 8 and 9, which creates a conflict with the CAN bus.)
Pax,
Mo
According to the instructions, I should be editing 3 and 5, but I don't have 5. I have 0,1,2,3,4. 5 is greyed out.
The picture in the docs shows UARTS 0,2,3,4,5. What GPIO pins should I be enabling? (UART3 says 8 and 9, which creates a conflict with the CAN bus.)
Pax,
Mo
