2024-03-04, 07:52 PM
Hi all
I'm implementing openplotter and pypilot in a 42 foot steel yacht with a hydraulic autopilot. The nano/ibt-2 and pi will be 5M apart.
I need help with connection between the nano and pi and connecting a NEO-6M gps to the pi.
Power supply:
I plan to use an LM2596 connected to the 5V pin of the nano. Should 5V from the same LM2596 also run the pi or do I need another LM2596?
Serial data:
Can I use cat6 cable between the nano and pi?.
GPS:
Is the NEO-6M up to the job? If so how do I connect a NEO-6M gps to the pi, if not whats the best alternative.
IMU:
Ive got an ICM20948 on the way. I plan to mount this on top of the cabin. Can I use cat6 to connect to the pi?
Thanks for your time?
I'm implementing openplotter and pypilot in a 42 foot steel yacht with a hydraulic autopilot. The nano/ibt-2 and pi will be 5M apart.
I need help with connection between the nano and pi and connecting a NEO-6M gps to the pi.
Power supply:
I plan to use an LM2596 connected to the 5V pin of the nano. Should 5V from the same LM2596 also run the pi or do I need another LM2596?
Serial data:
Can I use cat6 cable between the nano and pi?.
GPS:
Is the NEO-6M up to the job? If so how do I connect a NEO-6M gps to the pi, if not whats the best alternative.
IMU:
Ive got an ICM20948 on the way. I plan to mount this on top of the cabin. Can I use cat6 to connect to the pi?
Thanks for your time?