2019-06-09, 01:01 PM
e-sailingSignalK uses SI units (for pressure Pa).
[quote pid='9117' dateline='1559928543']
Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked?
If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only))
[/quote]
Thank you very much for your reply.
What you propose I have already done, but the value does not change only the units
[quote pid='9117' dateline='1559928543']
Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked?
If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only))
[/quote]
Thank you very much for your reply.
What you propose I have already done, but the value does not change only the units