2018-07-25, 11:23 PM
(This post was last modified: 2018-08-01, 03:57 PM by bhavers.
Edit Reason: No response on message, maybe not a clear title?
)
Hi,
my Rayamrine Ray60 VHF/radio does not pick up the GPS positioning data that i send out with OpenPlotter 1.0.0 on a Pi with Moitessier HAT and CAN-USB.
I know that OP is broadcasting the positioning data, because i can see it on my Raymarine i70s displays. So it is on the NMEA2000 / STNG network.
I suspect that the radio/vhf expects another PGN (129029), than OP is currently sending (129025) because:
- the Ray60 manual indicates (at page 112) that it expects 129029 GNSS position data.
http://www.raymarine.nl/view/?id=10805
- In OpenPlotter i see on the CAN tab that it sends PGN 129025 Position (and PGN 192026 SOG). But it does not send PGN 129029.
How can i manually add PGN 129029 to the SignalK to N2K converter?
Kind regards,
Bram.
my Rayamrine Ray60 VHF/radio does not pick up the GPS positioning data that i send out with OpenPlotter 1.0.0 on a Pi with Moitessier HAT and CAN-USB.
I know that OP is broadcasting the positioning data, because i can see it on my Raymarine i70s displays. So it is on the NMEA2000 / STNG network.
I suspect that the radio/vhf expects another PGN (129029), than OP is currently sending (129025) because:
- the Ray60 manual indicates (at page 112) that it expects 129029 GNSS position data.
http://www.raymarine.nl/view/?id=10805
- In OpenPlotter i see on the CAN tab that it sends PGN 129025 Position (and PGN 192026 SOG). But it does not send PGN 129029.
How can i manually add PGN 129029 to the SignalK to N2K converter?
Kind regards,
Bram.