This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My Openplotter setup
#1
Here is a video of my setup:

https://youtu.be/enPFlHpmJVA
Reply
#2
thanks for sharing!
Reply
#3
Thumbs up from me ? always good to see what others have done
Reply
#4
Thanks guys.

I hope to record a bit more when in the water, as well as a episode on the Monitor. I may do one covering OP3 install from scratch as well, but that may be in the fall - boat projects are for non-sailing season (we only get 5 months here in the Great Lakes!)

@Boatingbaileys I may do a video on the install of a ESP32 on the 3GM30F engine - I will reference your video and focus on how to set it up on my particular engine. the Dev Board hasn't arrived yet
Reply
#5
@Boatingbaileys:  

the Heading path is 'self.navigation.courseOverGroundTrue' and the source was the USB GPS.
   

hopefully that helps?
Reply
#6
Thanks for that. Strangely I think I have an issue in KIP. I can’t get it to save the settings on that path, I don’t get an error but when I go back in the source is blank again. I’ve tried random ones in there too to change it but I always clears the source. I’ll have to investigate further…
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)